LIMITED SUPPLY ONLY Burndy M10S-1 crimp tool frame combined with an S-1 die set and SL-53 locator. New Surplus crimp dies, with a used hand tool and locator. Mfg: Burndy Condition: Used
Daniels Y587 crimp die is designed for use in the HX4 crimp tool frame or any M22520/5-01 tooling. This die performs the same function as Tyco 220015-1. Mfg: Daniels Condition: New Surplus
The 400BHD is for Commercial, Aerospace and Military Applications, it can crimp insulated terminals 26-24 to1/0 AWG, unisulated terminals 26-2/0 AWG, contacts pins and sockets 28 to 2/0AWG. With a full cycle design that will insure a perfect crimp on every contact that meets
This is a Hand held tool is portable and uses both air and 110 volt, to create heat. When pressure has reach 50 PSI at the control unit, it will emit heat from the handle at about 500 F Tool has been Manufacturer: RaychemCondition: Used
Controlled ratchet cycle hand crimp tool. For crimping insulated PIDG terminals and splices, sizes 14-16 and 18- 22 AWG. It is a dual crimp, crimps both the wire and insulation at the same time. Manufacturer: AMP Tyco Condition: Used
The mil-spec M22520/2-01 is a crimp tool designed for machined pin and socket contacts with wire barrel sizes 20-28. Dial selectable, 8 indent crimp, controlled cycle ratchet - requires appropriate bayonet positioner determined by the contact part number. Manufacturer: Daniels Condition: Used
Relay Mfg: Abbott Condition: New Surplus
Notice: We ONLY charge sales tax, if your bill to, or ship to address, is IN the state of TEXAS. If you are IN the state of TEXAS, and you are tax exempt. Contact us directly to place an order.